RFI Emission OS-214plus User Manual download pdf (Page 14)

Performing Calibration

1. Keep pressing the feed button while turning on the power, until

the printing motor becomes activated.

2. The calibration has been performed while the printer

automatically feed label stock for certain length.

Note:

This step is very important and must always be carried

out whenever media is being changed. Failure to do so

will result in miss-detection of the label sensor.

Printing Configuration Report

1. Keep pressing the feed button while turning on the power, until

the printing motor becomes activated.

2. After feeding 12-inch blank media, the printing motor will

suspend for one second, then it will print out the configuration

profile. This profile states the firmware version, ROM checksum,

RS232, thermal transfer/direct thermal settings, hardware

configuration and font types.

3. At PPLB emulation, the printer will enter character dump mode.

To exit from dump mode, just press the feed button again.

Resetting the Printer to Factory

Default Settings

1. Turn on the printer and wait for 5 or more seconds.

2. Press "Feed" button for about 10 seconds, then the "Ready"

indicator and "Power" indicator will go off in order.

3. While two indicators become lit again, release the feed button.

4. At this moment, the printer will feed the label stock 12 inches in

length, and come back to the factory default settings.

Note :

All settings are stored in non-volatile E2PROM and

cannot be destroyed even turn off the printer.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

No comments

RFI Emission OS-214plus User Manual Page 14